Techniques for aligning projector pattern?

[The_Nephilim]

[BHawthorne]

This weekend I got blind-sided with a few things, so in order to properly get the time lapse done I'll push it to Monday-Tuesday time frame. I suppose I was a bit optimistic that things would go smooth this weekend. I think I need to learn to multi-task a bit better. *chuckle*

Here's to hoping Monday-Tuesday work out better than Saturday-Sunday did in allocating spare time to the time lapse project.

-Brad

[Shack]

Nthusim is running great. Have a beautiful 3 screen picture.

However, as I have 5 additional screens for my F16 sim, I can only get 4/5 to show imagery. The remaining display shows powered but only shows a "no sync" message. I believe my setup with 2 AMD 7970's is powerful enough to handle my 8 screens ( triple projector, 2 MFD's, 1 ATD, 1 HUD, ) plus my CPD display? I'd hate to connect another PC in a server / master setup as I want the hard wire connection reserved for an Ethernet high speed connection.

Windows control panel identifies all 8 screens but when I click identify it shows all except the Center Pedestal Display ( CPD) as shown in the video below.

Here's a vid of the setup for additional info. Note the CPD is powered but not displaying



Any recommendations or thoughts would be appreciated.

Thank you.

[BHawthorne]

It shouldn't be an issue of power. It'll either work or not. My guess is that either the connection is bad or the display is. If 4 of the 5 are working, no reason why the 5th shouldn't also. Have you attempted to run the display seperately to see if it works on it's own?